One more item.
If your program does not programatically set the baud/parity/stop bits,
etc you will need to set your device to 9600, 8, N, 1 to match the
defaults of utseriald.
An example would be a serial printer that defaults from the factory at
19200/8/N/1. Since you can't configure export comports via the control
panel ports util, you have to make the printer match the default of
utseriald.
If you ever have to do this for an Epson Dot Matrix printer, I feel for you.
Craig Bender wrote:
Hi Joe,
The correct command would be
comport:com1=/tmp/SUNWut/units/IEEE802.00144f2179c7/dev/term/b
Now a couple of things:
I mention using using /dev/term/b because /dev/term/a is not a full
fledged port.
You application should list serial ports and your should see
\\tslcient\com1
If your application does not see those ports list you can do the
following:
net use com5: \\tsclient\com1
Now you could use com1 or com2 in the net use statement, but those are
most likely physically on your computer. In order to use those via
RDP you would have to disable them in the bios.
Hope that helps.
Joe Toth wrote:
Greetings,
I am working on a pilot deployment of SunRay's and I am having some
trouble getting the COM Ports on a SunRay 170 to map over to an RDP
Session using the SunRay Windows Connector. I have a Topaz Systems
electronic signature pad connected to the SR that I am trying to use
inside of Windows.
The connector starts up without error but the COM port is not
available in Windows.
Here is the command that I am using to start the SunRay connector and
connect it to the Windows Host, which in this case is a Windows XP
Pro machine.
uttsc -m -r
comport:1=/tmp/SUNWut/units/IEEE802.00144f2179c7/dev/term/a
192.168.0.XXX
I was hoping that someone could take a look at the command and let me
know if the Syntax is correct to allow this port to be mapped into
Windows XP. I am new to using the SunRay's and I can't seem to find
any examples of the proper usage of this command, as Sun seems to
refer to the COM ports as A and B where in Windows I assume that they
should be showing up as COM 1 and 2. I'm guessing that something in
the COM name or device path is probably incorrect so I hope that
someone might be able to provide an example of what the proper Syntax
to map COM1 on a SunRay 170 as well as using a USB/Serial Adapter on
a SunRay 2 to map COM1 would look like.
Thanks in advance
Joe Toth
Tier 5 Solutions Group
E: [EMAIL PROTECTED] <mailto:[EMAIL PROTECTED]>
P: (866) 661-6736
F: (866)-888-4613
------------------------------------------------------------------------
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
