Thanx Craig, but my problem is a bit bigger than that. For instance;
When I login on a 2FS with 2 17" screens attached there are two modes of interest supported: (example) 4.1280x1024 *5. 2560x1024 My collegue has a 1680x1050 screen. Upon insertion that mode will be unavailable. The other way around this screen only supports 1280x960; so: 4.1280x960 *5 1680x1050 So again, no correct resizing. Therefore using utxconfig to force any resolution to 1680x1050 won't only result in some weirdness (panning on the login- and OSD-screens), but won't fix this nasty either. Greetz 2009/2/11 Craig Bender <[email protected]> > Yes, search the archives for the thread " system wide utaction" around > December 16th 2008. There is a script called utfit written by Bob > Doolittle. Good info on that whole thread. > > Just remember that you can only go down or up to the original session, so a > good trick is to use utxconfig to set a default res that equals your largest > possible starting resolution. > > The Loeki wrote: > >> Hi all, >> >> With the new SRSS one of the best changes was the introduction of the >> XRandR extension. >> >> But we noticed the available modes in XRandR don't get updated when you >> insert your card in another Sun Ray. >> >> Is there a way to insert custom modes or force the mode list to update >> upon reinsertion? >> >> Regards, >> >> Ronald >> >> >> ------------------------------------------------------------------------ >> >> _______________________________________________ >> SunRay-Users mailing list >> [email protected] >> http://www.filibeto.org/mailman/listinfo/sunray-users >> > _______________________________________________ > SunRay-Users mailing list > [email protected] > http://www.filibeto.org/mailman/listinfo/sunray-users >
_______________________________________________ SunRay-Users mailing list [email protected] http://www.filibeto.org/mailman/listinfo/sunray-users
