Do you just have the one network interface eth0?
What does the "hostname" command report, is it "helios"?
The "dedicated network" setup is intended for hosts with two (or more)
network interfaces where one interface is assigned the IP address
corresponding to what "hostname" reports and is connected to your LAN,
and one interface is not yet configured at all but is connected to an
isolated subnet containing Sun Rays. Is that your situation?
If you only have a single network interface, then presumably you want
that connected to your LAN, and have Sun Rays on your LAN. In that case
you should be using the "utadm -A <subnet>" or "utadm -L on" commands,
not "utadm -a <interface>".
If you really want an isolated Sun Ray Server that's not connected to a
LAN, and is only connected to an isolated network of Sun Rays, then you
can use "utadm -A <subnet>" or "utadm -L on". That's not a typical
situation since a server not connected to a LAN isn't typically very
useful, but if you want to do that it's simplest to pretend that your
isolated subnet is a LAN and use the LAN commands.
-Bob
shambalad wrote:
Hello All,
I have the following. I want to setup on a dedicated network.
When machine boots and separated from lan (no dhcp)
./utadm -a eth0
### Configuring /etc/nsswitch.conf
### Configuring Service information for Sun Ray
Interface "eth0" is already configured as
hostname "helios"
To configure eth0 as a dedicated interconnect:
remove the file /etc/opt/SUNWut/net/hostname.eth0 and
remove the host entry helios or use a different hostname.
Please use the -A option to configure support for shared networks.
Can't get this configured.
When I boot onto lan(w/dhcp)
./utadm -a eth0
### Configuring /etc/nsswitch.conf
### Configuring Service information for Sun Ray
### configuring eth0 interface at subnet 192.168.128.0
Selected values for interface "eth0"
host address: 192.168.128.1
net mask: 255.255.255.0
net address: 192.168.128.0
host name: helios-eth0.testray.org
net name: SunRay-eth0
first unit address: 192.168.128.16
last unit address: 192.168.128.240
auth server list: 192.168.128.1
firmware server: 192.168.128.1
router: 192.168.128.1
Accept as is? ([Y]/N): n
Everything else on the server looks to be ok.
Any thoughts? I need this on it's own network at the momemt.
M
------------------------------------------------------------------------
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
_______________________________________________
SunRay-Users mailing list
[email protected]
http://www.filibeto.org/mailman/listinfo/sunray-users
