Michael Kaszuba wrote: <snip> > The drive I have starts at page 4 I think, because on the bottom of the > drive I have a TE and a TP setting which are both jumpered (closed). > > My question is, how would I set this Viking drive up to the only unit on the > wide scsi bus? I am also assuming that because "drive setup lite" dones not > complete the bus scan (I have to force quit it) that it has to be a > termination problem. PS my controller is a 3490UWD which has no jumpers on > it. My E100 card still hangs the system on boot up. >
mike, It sounds like it is set up to be the only (or last) device on the bus. I did not look at your reference, but I am assuming that TE=termination enabled and TP=term power. You will have to check the docs on the 3940UWD to see if it provides term power. Although I have run a bus with multiple sources of term power, I do not think that it is the proper way (i.e. it is not harmful but also not recommended). Both ends of the chain need to be terminated, and once again I am assuming that the 3940UWD terminates its end automagically. E100 might be a firmware issue??? tom -- SuperMacs is sponsored by <http://lowendmac.com/> and... Small Dog Electronics http://www.smalldog.com | Refurbished Drives | Service & Replacement Parts [EMAIL PROTECTED] | & CDRWs on Sale! | Support Low End Mac <http://lowendmac.com/lists/support.html> SuperMacs list info: <http://lowendmac.com/supermacs/list.shtml> --> AOL users, remove "mailto:"; Send list messages to: <mailto:[EMAIL PROTECTED]> To unsubscribe, email: <mailto:[EMAIL PROTECTED]> For digest mode, email: <mailto:[EMAIL PROTECTED]> Subscription questions: <mailto:[EMAIL PROTECTED]> Archive: <http://www.mail-archive.com/supermacs%40mail.maclaunch.com/> --------------------------------------------------------------- >The Think Different Store http://www.ThinkDifferentStore.com ---------------------------------------------------------------
