Hi, Here is what i do:
- Go to Firewall > Virtual IP and Create a Virtual IP as CARP, with your x.y.18.20 - Go to Firewall > NAT and set Manual Outbound NAT rule generation (Advanced Outbound NAT (AON)) - Then add a rule for your outgoing server/ip, in the Translation section you will find your x.y.18.20 ip address. r@ On Sun, Dec 27, 2009 at 11:38 AM, Michel Servaes <[email protected]> wrote: > I have a pool of ip-adresses... the gateway is x.y.18.17, and the > ending is x.y.18.22 > I have two servers, that use the same outgoing protocol and the first > is working fine, as I have setup a rule to use the default gateway > .18.17 on the WAN side. > > But I want to setup the second server to go out on .18.20 for > instance... but setting up rules, will allow me only to choose > "default" or ".18.17" (mind you, that the "default" is a second > network card, used for backup) > I have added virtual ip's (.18.18, .18.19, .18.20, ...), but cannot > choose them for outgoing rules... I'm sure I'm missing something basic > here. > > Kind regards, > Michel > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > > Commercial support available - https://portal.pfsense.org > > --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
