On Sun, Dec 27, 2009 at 1:49 PM, Michel Servaes <[email protected]> wrote: > >> - Go to Firewall > Virtual IP and Create a Virtual IP as CARP, with >> your x.y.18.20 >> - Go to Firewall > NAT and set Manual Outbound NAT rule generation >> (Advanced Outbound NAT (AON)) >> - Then add a rule for your outgoing server/ip, in the Translation >> section you will find your x.y.18.20 ip address. >> >> r@ >> >> >> > > The 2 first instructions went just fine. > The third one, seems to be not working for me. > > I tried adding an outbound rule on the LAN interface (since it should be > listening to the inside of my network ?) > I've added the internal ip 192.168.150.9/32 as source, and used the virtual > ip .18.20 as translation. > Also tried adding 192.168.150.9/32 as destination, just to make sure I > didn't mistake myself - but this seems not to work either... > > I tried to check using upon http://checkip.dyndns.org to see if my outgoing > connection would be using x.y.18.20, but instead it uses my default LAN to > ADSL backup route (a dynamic ip). > When I disable my default LAN to ADSL route; no comms are possible no more > to the internet. > > I have a "SERVERS" rule to make them by default go over to WAN2 (first IP of > that range by default : .18.18) > Default LAN to ADSL route is setup for all leftovers that any other rule > isn't taking care of. > > I would like a "SECOND SERVER" rule, to make them by default go over to WAN2 > (second IP of that range : .18.20) > > > So you have the default outgoing NAT rule for your LAN and then the rule for your second server, both are on the same subnet 192.168.150.x Try to move it above the default LAN rule and see if it works
r@ --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
