ok, tomorrow i'll check the connector and send you photos. thanks
2012/3/20 Oleg <[email protected]> > Well, could you please double check the fixed connector? > 1. Try gently touching a pin with a needle and see if any of them moves. > 2. I'd also check the connector pins for short circuit. > > It seems to be the only place. > How was it tested? Did you use the circuit diagram of the 10369? > Could you send a picture of the connector? > > Regards, > Oleg > > On 19 March 2012 16:48, Carlos Padial <[email protected]> wrote: > >> i get this >> ----------- >> >> Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2 >> >> ide: Assuming 50MHz system bus speed for PIO modes; override with >> idebus=xx >> >> ide: ETRAX FS built-in ATA DMA controller >> >> cris_ide_init() >> >> Initializing USB Mass Storage driver... >> ----------- >> >> i hear the disk when starting the camera and the motor stopping when >> switching off, and a little zzz while working. >> >> >> 2012/3/19 Oleg <[email protected]> >> >>> Also, can you here the noise when the HDD is working? >> >> >> >> >> -- >> Carlos Padial >> surreal.asturnazari.es >> >> _______________________________________________ >> Support-list mailing list >> [email protected] >> http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com >> >> > -- Carlos Padial surreal.asturnazari.es
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
