ok, tomorrow we will do a new round of tests and wrote down a table. I have a few questions: about "ifconfig" and "mii-diag" output?
i have to use this commands in the ttylog? when i put commands there, nothing seems to happend... > Could you also check the network statistics - packets/lost packets? > Do you have lost packets before streaming? After? can you provide us more instructions about how to check this? >if the camera is not streaming, just connected - will it continue to be accessible after a long time? need to check this... >What about recording to the external SATA HDD - does it work? Or also fails? it works fine if i record without stream (at any resolution), if i run one of them while the other is running then it breaks... 2012/6/5 Andrey Filippov <[email protected]> > Hello Carlos, > > Shipping camera back and fourth can be expensive, so I'm trying to make > sure it can be a hardware problem related to fixing the 10369 board with > the connector that fell off. I can not think of any type of failure that > can manifest itself in that way. So I would try to make a table - what > works (always) and what does not. Can you make such table, using the > previous results and add some more? > I would test streaming and really low data rate (low fps and/or image > quality) with the serial port of the camera connected to the camera and > monitored, and streamer (str) killed and restarted from console (so output, > if any will go to console). If the streamer will fail - what happens to the > camera: > 1 - the serial console connection will be dead, > 2 - serial console will continue to be operational, but no network > connection (can not ping camera from outside) > 3 - console alive, network alive > In the case of the network down - what will the "ifconfig" and "mii-diag" > output? > > Another test - if the camera is not streaming, just connected - will it > continue to be accessible after a long time? > What about recording to the external SATA HDD - does it work? Or also > fails? > > Andrey > > > > > On Tue, Jun 5, 2012 at 11:14 AM, Carlos Padial <[email protected]> wrote: > >> Dear Andrey, >> >> we hope everything's fine around there. We get in touch with you because >> we've tried to sort out the problems we've had. As you suggested we would >> like to send it to Utah so you could check and fix it. >> >> We hope you can help us with this. Could you please specify the shipment >> details (customs procedures and others)? Should we send just the camera >> body in its case? >> >> Thank you very much for all your support >> >> Best wishes >> >> >> >> > -- Carlos Padial surreal.asturnazari.es
_______________________________________________ Support-list mailing list [email protected] http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
