Linden, > I have a /dev/ttyUSB0 > that registered when the USB to serial is plugged in so good up to that > point. Have minicom setup as follows: > Bps/Par/Bits: 115200 8N1 > Hardware Flow Control: No > Software Flow Control: No
Looks correct. > Then I assume I just start minicom and it should start printing output to > the screen or is there some step I am missing? Yes. 1. power on the camera 2. ~$ sudo minicom -c on 3a. Hit Enter - it should print "#", or type "dmesg". 3b. If it's not doing anything - w/o terminating minicom powercycle the camera. And it should be printing. If it's not responsive - I would check the cable. Regards, Oleg _______________________________________________ Support-list mailing list Support-list@support.elphel.com http://support.elphel.com/mailman/listinfo/support-list_support.elphel.com
