Thanks. I think I did forget to exit the Quickstarter. However I realized how much I depend on the tab session manager in the Multizilla add-on and I would lose all my currently saved sessions (I do a lot of research) so I think I will hold off on the upgrade until Multizilla has a SM2 compatible version out.
On Nov 4, 2:02 am, Martin Freitag <[email protected]> wrote: > Stephanie : schrieb: > > > I am having a similar problem. Last night I installed Seamonkey 2.0 > > over top of 1.1.18. The installation went well and at the end it > > opened 2.0 and I used it for a while. > > > This morning I booted up my computer and opened Seamonkey only to find > > that it is still 1.1.18! Add/Remove programs shows 2.0 installed. > > Searching the hard drive shows 2 installations: Program Files/ > > Seamonkey and Program Files/mozilla.org/Seamonkey, however the > > Seamonkey.exe file in both of these only opens 1.1.18. > > I suspect your SM1.1.18 has already been running at that time (maybe > you're using the Quickstarter?), they can't run together at the same > time without additional effort. > So make sure SM1.1.x is _not_ running, the Quickstarter next to your > clock is closed (no seamonkey.exe in the process list in the > taskmanager), then start your SM2. (you can verify that you're starting > the correct seamonkey.exe by right-clicking, selecting properties and > navigating to the "version" tab. Open "Product version" below in the > list and it should say 2.0) > regards > > Martin > -- > () ascii ribbon campaign - against html e-mail > /\ www.asciiribbon.org -http://www.gerstbach.at/2004/ascii _______________________________________________ support-seamonkey mailing list [email protected] https://lists.mozilla.org/listinfo/support-seamonkey
