At 03:27 PM 9/6/2005, Richard Davis wrote:
This is probably a newbie question but I have loaded pfsense on the hard
drive on PC "A" and have a cross over cable going to another PC(PC B).
I configured the PC "B" with an IP in the same range(192.168.1.10\24
.....the default on the pfsense box is 192.168.1.1\24). I can not http
or ping box "A" from box "B" so I told box "A" to ping its IP
address(192.168.1.1). I get a no route to host.
I know that the 2 PC's and their ethernet cards work because I loaded
Star-os on one and pinged it from the other(Win 2000). My install was
stright from the installer command off a CD that booted.
Normally I don't have this type of problem. I figured that an generic
install from the CD would not cause problems. Any suggestions? Thanks
in advance
i've had the same issue if i didn't configure the WAN port first. try that...
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
