Not easily. The code detects that you have a fxp driver and then tries to init the code. I suppose we could add a tag to <system><do_not_use_nic_microcode> or something...
On 9/29/05, J B <[EMAIL PROTECTED]> wrote: > Is there anyway to turn off the microcode on a per/NIC basis? I only have > older Pro100 cards - (trying to recycle some old equipment and make it > usefull again) > > JB > > On Thu, September 29, 2005 1:14 pm, Scott Ullrich wrote: > > I suspect the microcode is borking the NIC. Do you have a newer > > NIC that you could try? I would rather not remove the microcode > > support as it works wonders for newer cards. > > > > Scott > > > > > > > > On 9/29/05, J B <[EMAIL PROTECTED]> wrote: > > > >> Well - it keeps timing out, I wish I had the machine in front of me so > >> I > >> could send the actual error - but it keeps saying that the microcoad > >> load is timing out > >> > >> JB > >> > >> > >> On Thu, September 29, 2005 1:08 pm, Dan Swartzendruber wrote: > >> > >>> At 12:48 PM 9/29/2005, you wrote: > >>> > >>> > >>>> yes - it shows up as fxp0 - but then I get errors loading microcode > >>>> - > >>>> and it just don't work on the network > >>> > >>> "gets errors". can you be more specific? > >>> > >>> > >>> > >>> > >>> > >>> --------------------------------------------------------------------- > >>> To unsubscribe, e-mail: [EMAIL PROTECTED] > >>> For additional commands, e-mail: [EMAIL PROTECTED] > >>> > >>> > >>> > >>> > >> > >> > >> > >> --------------------------------------------------------------------- > >> To unsubscribe, e-mail: [EMAIL PROTECTED] > >> For additional commands, e-mail: [EMAIL PROTECTED] > >> > >> > >> > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > > > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]