I apologize for the late response on the 0.93 PPPoE items. I'll do my
best to describe my issue when I upgraded. I do not have a ton of
specifics, but I'll do my best and fetch anything extra that is needed.
When I upgraded t0 0.93, upon reboot, my machine was not connected to
the internet and I had an error with the ng0 interface that was not
allowing it to connect. I believe the error was that the interface did
not exist.
To fix this issue, I ended up going in to the configuration of the WAN
interface and changing it to DHCP and then back to PPPoE and it then
connected and has been working fine.
The same thing happened today when I came to the office. I was
connected to my network last night from home and the connection was up
and all was well. But, today when I came in, the interfaces page showed
the connection was up with an IP. I could connect to the LAN side of
pfSense no problem, but could not get out of the LAN to the internet
from either a PC on the LAN or from pfSense itself (with the ping util).
I ended up doing the same thing as the other day and switching my
connection to DHCP and then back to PPPoE. I tried to force the PPPoE
connection down from the interfaces page and it never seemed to go down.
I rebooted my DSL modem and then rebooted pfSense and still nothing.
After the reboot, on the interfaces page it showed:
Status - Down
PPPoE - Up
But gave no info about MAC, IP, Subnet, etc. Only Status and PPPoE were
showing.
This is probably already known, but in case it is not, the shaper does
not work with my connection. I get an error saying that ALTQ is not
supported on ng0. My intent is not to gripe about shaping on PPPoE, I
just wanted to make it known in case there had been work done in this
area and it was thought to be working. Since it looks like we can
choose the interface to shape on (I left the defaults in there when I
ran the wizard), can I shape on the LAN for now and get any shaping
until shaping on PPPoE works? Just curious.
If you need any log info, etc, just let me know.
It should also be known I am on the 0.93 version that came out
originally. I believe there was another version created after that.
Not sure if the changes between my version and that one matter, but I
wanted to note that too.
Thanks,
Brian
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
