Hello all,
I've been playing with the traffic shaper and have basically discovered
that it is not tagging the RTP streams as high priority. I'm using a
Cisco ATA-186 with Vonage.
Last time I brought this up, someone said that altq/pf "Just Works" in
this case, assigning anything with low delay TOS set to the high priority
queue by default. It doesn't seem to be doing that. Since turning on the
shaper, I get complaints from my co-workers that my voice is cutting in
and out. Looking at the nifty queue-status web gui I see that both
inbound and outbound rtp is hitting the default queue.
I'll also note that doing an upload via ftp or scp gives me quite a lag on
all my ssh sessions as well, which are also supposed to land in the high
priority queue.
The first thing I wanted to do to show this was to run tcpdump on the
pfsense box, but there's no bpf device. Any hints on getting that on
there? I'm running beta-1. As far as I can tell, this device can't be
kldloaded.
Thanks,
Charles
___
Charles Sprickman
NetEng/SysAdmin
Bway.net - New York's Best Internet - www.bway.net
[EMAIL PROTECTED] - 212.655.9344
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
