Hi,
I just recently updated my laptop (Toshiba Portege 3110CT) with
pfSense 1.0-BETA1-TESTING-SNAPSHOT-2-8-06. The system refused to boot
up, the kernel would panic after loading up the Realtek drivers for
the D-Link DFE-690TXD. The system would constantly reboot after 15
seconds, this did not happen with the pfSense
1.0-BETA1-TESTING-SNAPSHOT-2-5-06 firmware update.
I tried different boot configuration but that didn't work. Once I
removed the card, the system booted up without any problems using the
internal NIC (Intel Etherexpress/100). I was able to reload the
previous snapshot and everything started to work again.
The following is the error that was outputed:
rl0: <D-Link DFE-690TXD 10/100BaseTX> port 0x1010-0x110f mem
0x88000000-0x880001ff at device 0.0 on cardbus0
rl0: unknown device ID: ffff
Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address = 0x60
fault code = supervisor read, page not present
instruction pointer = 0x20:0xc080bfe1
stack pointer = 0x28:0xca6acc40
frame pointer = 0x28:0xca6acc54
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 39 (cbb0)
trap number = 12
panic: page fault
cpuid = 0
Uptime: 3s
Cannot dump. No dump device defined.
Automatic reboot in 15 seconds - press a key on the console to abort
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
