Try the machine on the latest FreeBSD snapshot and see if it does the same.
On 2/9/06, Insik Lee <[EMAIL PROTECTED]> wrote: > Hi, > > I just recently updated my laptop (Toshiba Portege 3110CT) with > pfSense 1.0-BETA1-TESTING-SNAPSHOT-2-8-06. The system refused to boot > up, the kernel would panic after loading up the Realtek drivers for > the D-Link DFE-690TXD. The system would constantly reboot after 15 > seconds, this did not happen with the pfSense > 1.0-BETA1-TESTING-SNAPSHOT-2-5-06 firmware update. > > I tried different boot configuration but that didn't work. Once I > removed the card, the system booted up without any problems using the > internal NIC (Intel Etherexpress/100). I was able to reload the > previous snapshot and everything started to work again. > > The following is the error that was outputed: > > rl0: <D-Link DFE-690TXD 10/100BaseTX> port 0x1010-0x110f mem > 0x88000000-0x880001ff at device 0.0 on cardbus0 > rl0: unknown device ID: ffff > > > Fatal trap 12: page fault while in kernel mode > cpuid = 0; apic id = 00 > fault virtual address = 0x60 > fault code = supervisor read, page not present > instruction pointer = 0x20:0xc080bfe1 > stack pointer = 0x28:0xca6acc40 > frame pointer = 0x28:0xca6acc54 > code segment = base 0x0, limit 0xfffff, type 0x1b > = DPL 0, pres 1, def32 1, gran 1 > processor eflags = interrupt enabled, resume, IOPL = 0 > current process = 39 (cbb0) > trap number = 12 > panic: page fault > cpuid = 0 > Uptime: 3s > Cannot dump. No dump device defined. > Automatic reboot in 15 seconds - press a key on the console to abort > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
