Enable firewall in advanced settings again. By disabling this setting you also shut down NAT which is enabled by default. Do you see your DMZ traffic blocked at status>systemlogs, firewall tab? If so click on the small block icon in front of the line. It will tell you which rule caused the block. If it returns something like "default block all just to make sure" your pass rule is not correct.
Holger -----Original Message----- From: Trevor J. Burt [mailto:[EMAIL PROTECTED] Sent: Thursday, May 04, 2006 3:08 PM To: [email protected] Subject: [pfSense Support] Firewall Problem Importance: High Dear Support I have installed Beta 3 as a firewall/router WAN is on a p2p address /30 LAN is on a private network for configuration only DMZ is on a /28 Traffic inbound from the WAN to DMZ works fine, However I am unable to connect to the Internet from the DMZ through the WAN interface. I am also unable to ping the DMZ's interface address, so I naturally thought it was a rule issue. I set a rule to Allow all from any address on both the WAN and DMZ interfaces. However I was still not able to ping the DMZ interface address. I then decided to disable the Firewall in the advanced settings and found I could ping the interface address on the DMZ, in addition I also found that the routing was now working and that I was able to connect to the Internet. I think there might be an issue with the Optional Interfaces and the Firewall rules. I would be most grateful for any help you can give me. ____________ Virus checked by G DATA AntiVirusKit --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
