Installing BETA4 on a Nokia IP110, I get this on the serial console:
================================================
Copyright (c) 1992-2006 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD 6.1-RELEASE #0: Mon May 8 22:36:35 UTC 2006
[EMAIL PROTECTED]:/usr/obj.pfSense/usr/src/sys/pfSense.6
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Geode(TM) Integrated Processor by National Semi (266.68-MHz 586-class CPU)
Origin = "Geode by NSC" Id = 0x540 Stepping = 0
Features=0x808131<FPU,TSC,MSR,CX8,CMOV,MMX>
real memory = 67108864 (64 MB)
avail memory = 56020992 (53 MB)
wlan: mac acl policy registered
kbd1 at kbdmux0
ath_hal: 0.9.16.16 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
cpu0 on motherboard
pcib0: <Host to PCI bridge> pcibus 0 on motherboard
pir0: <PCI Interrupt Routing Table: 3 Entries> on motherboard
pci0: <PCI bus> on pcib0
Fatal trap 12: page fault while in kernel mode
cpuid = 0; apic id = 00
fault virtual address = 0xeb11f
fault code = supervisor read, page not present
instruction pointer = 0x20:0xc00eb621
stack pointer = 0x28:0xc0c20a54
frame pointer = 0x28:0xc0c20a54
code segment = base 0x0, limit 0xfffff, type 0x1b
= DPL 0, pres 1, def32 1, gran 1
processor eflags = interrupt enabled, resume, IOPL = 0
current process = 0 (swapper)
trap number = 12
panic: page fault
cpuid = 0
Uptime: 1s
Automatic reboot in 15 seconds - press a key on the console to abort
Rebooting...
================================================
It never reboots either.
I've found a number of similar problems in the mailing list archives,
but no answers.
I'd like to try and fiddle with kernel ACPI and APIC options, but I
cannot seem to get to the boot loader through the console.. How do
you do that?
Alternatively, I'd like to replace the kernel that pfSense uses with
one that works OOTB on the Geode 5530 that my IP110 and IP120 uses.
How can that be accomplished, in general terms?
Any help would be much appreciated :-).
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
