All-
I am attempting to use a Seagate ST1.2 "Microdrive" (4GB) in my WRAP platform.
I imaged it with the embedded image as a start (I'll play around with
converting it to R/W later). I use the memory card reader on my printer to
write the image, which was a first (my CF/PC card adapter doesn't handle CF
Type II cards). The imaging process worked, although the printer is too
smart about these cards and I'm pretty sure I need a dedicated adapter for
this in the future.
Anyhow, the WRAP recognizes the CF drive in either CHS or LBA mode, no
problems there. The kernel boots, but GEOM doesn't recognize the drive, so
I have no bootable device. Snippet below.... any ideas?
====================
Geode PC Engines WRAP.1C/1D/1E v1.tinyBIOS V1.4a (C)1997-2005
isab0: <PCI-ISA bridge> port 0xf400-0xf43f,0xf600-0xf63f at device 18.0 on pci0
isa0: <ISA bus> on isab0
pci0: <bridge> at device 18.1 (no driver attached)
atapci0: <National Geode SC1100 ATA33 controller> port
0x1f0-0x1f7,0x3f6,0x170-0
x177,0x376,0xfc00-0xfc0f at device 18.2 on pci0
ata0: <ATA channel 0> on atapci0
ata1: <ATA channel 1> on atapci0
pci0: <multimedia, audio> at device 18.3 (no driver attached)
Geode CBA@ 0x9000
Geode rev: 06 03
Timecounter "Geode" frequency 27000000 Hz quality 1000
pci0: <bridge> at device 18.5 (no driver attached)
pmtimer0 on isa0
orm0: <ISA Option ROM> at iomem 0xe0000-0xe7fff on isa0
ppc0: parallel port not found.
sio0 at port 0x3f8-0x3ff irq 4 flags 0x30 on isa0
sio0: type 16550A, console
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
Timecounters tick every 10.000 msec
Fast IPsec: Initialized Security Association Processing.
Trying to mount root from ufs:/dev/ufs/pfSense
Manual root filesystem specification:
<fstype>:<device> Mount <device> using filesystem <fstype>
eg. ufs:da0s1a
? List valid disk boot devices
<empty line> Abort manual input
mountroot> ?
List of GEOM managed disk devices:
Manual root filesystem specification:
<fstype>:<device> Mount <device> using filesystem <fstype>
eg. ufs:da0s1a
? List valid disk boot devices
<empty line> Abort manual input
mountroot>
panic: Root mount failed, startup aborted.
--
Bill Plein
[EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
