On 11/16/06, Holger Bauer <[EMAIL PROTECTED]> wrote:
Output of embedded installs is at com1 only after it started to boot.
Connect your com1 and access it with a serial terminal.
Holger
> -----Original Message-----
> From: Tim Martin [mailto:[EMAIL PROTECTED]
> Sent: Friday, November 17, 2006 12:25 AM
> To: [email protected]
> Subject: Re: [pfSense Support] pfSense 1.0.1 in DOM (Disk on Module)
>
> How much RAM do you have?
>
> PlanAlpha wrote:
> > I had the same problem and tried every trick I could think
> of to make
> > it work. m0n0wall works fine on the same system and I even tried
> > copying it's mbr, installed gag, etc... but to no avail. Leaving it
> > alone for a while had no effect. I left it there beeping
> for hours and
> > it never booted. I tried installing it to a harddrive which did
> > beep/hang for a second and it does boot. I sure hope this
> gets figured
> > out because this location get very hot and I don't think a
> harddrive
> > would last long and m0n0wall doesn't have drivers for my 4
> port card.
> > /catch22
> >
> > On 11/16/06, Alvaro Pietrobono <[EMAIL PROTECTED]> wrote:
> >> Hi,
> >> I'm trying to install pfsense 1.0.1 on 512Mb Disk on
> Module devices
> >> but unseccessfully.
> >> On reboot (after installation has finish) it stops in bootloader
> >> displaying "F1" and sounds a beep tapping any key of keyboard.
> >> Any ideas?
> >> thanx
> >>
> >> ~Alvaro
> >>
> >>
> >>
> >>
> >>
> >> --------((((((( Internet Email Confidentiality Footer
> )))))))--------
> >>
> >> This e-mail, including any attachments, may contain
> information that
> >> is protected by law as privileged and confidential, and is
> >> transmitted for the sole use of the intended recipient.
> If you are
> >> not the intended recipient, you are hereby notified that any use,
> >> dissemination, copying or retention of this e-mail or the
> information
> >> contained herein is strictly prohibited. If you have
> received this
> >> e-mail in error, please notify immediately the sender by
> telephone or
> >> reply by e-mail, and permanently delete this e-mail from
> your computer system.
> >> The statements and opinions expressed in this e-mail message are
> >> those of the author of the message and do not necessarily
> represent
> >> those of List Group S.p.A. Besides, the contents of this message
> >> shall be understood as neither given nor endorsed by List
> Group S.p.A.
> >> List Group S.p.A. does not accept liability for corruption,
> >> interception or amendment, if any, or the consequences thereof.
> >>
> >>
> ---------------------------------------------------------------------
> >> --
> >>
> >>
> >>
> >>
> ---------------------------------------------------------------------
> >> To unsubscribe, e-mail: [EMAIL PROTECTED] For
> >> additional commands, e-mail: [EMAIL PROTECTED]
> >>
> >>
> >
> >
> ---------------------------------------------------------------------
> > To unsubscribe, e-mail: [EMAIL PROTECTED] For
> additional
> > commands, e-mail: [EMAIL PROTECTED]
> >
> >
>
> --
>
> Stop Spam Now: http://www.spamarrest.com/affl?4025320
>
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [EMAIL PROTECTED] For
> additional commands, e-mail: [EMAIL PROTECTED]
>
>
>
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
I tried both the livecd and the embeded install. Neither of them get
past the "Press f1" and beeping stuff. Never boots far enough to
initialize com 1, doesn't even load the kernel.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
