Holger Bauer <[EMAIL PROTECTED]> writes: > > Sure, go to Services>DHCP in the webgui. You'll notice a seperate tab for each internal interface you have > (like your OPT1, it's labeled with the interface name). Switch to that tab and make your settings. > DHCP-Server in pfSense is per Interface, so you can have different DHCP-settings for each of your interfaces. > > Holger > > > -----Ursprüngliche Nachricht----- > > Von: Nate Davis [mailto:[EMAIL PROTECTED] > > Gesendet: Montag, 2. Januar 2006 18:39 > > An: [EMAIL PROTECTED] > > Betreff: [pfSense Support] DHCP Server on OPT1 > > > > > > Hello Everyone, > > > > Could someone detail for me what I need to do to enable the > > DHCP server > > for OPT1 and the LAN interface? It is running great on LAN, > > but I need a > > DHCP server running on the OPT1 Interface. Is this even > > possible? The > > Subnet for OPT1 is 192.168.60.0/24 (OPT1 is 192.168.60.1). > > > > Thanks, > > Nate > > > > --------------------------------------------------------------------- > > To unsubscribe, e-mail: [EMAIL PROTECTED] > > For additional commands, e-mail: [EMAIL PROTECTED] > > > > > > ____________ > Virus checked by G DATA AntiVirusKit >
Hi All, I am setting up pfsense on my wrap board for the first time so maybe I just missed something... I am trying to get dhcp server to serve address to wireless clients. I see in this post that on the "services" page under "dhcp server" there 'should' be another tab for the opt1 aka ath0 interface where I can configure the dhcp server specific for this interface... but it isn't there. Version of code I am running is: 1.0.1 built on Sun Oct 29 01:45:08 UTC 2006 The wrap board has 2 minipci slots, 1 of which holds my atheros card, plus it has 2 10/100 interfaces. Do I need to enable some form of port forwarding? I don't think that should be necessary. I thought that by bridging the wireless and LAN interfaces, that would be enough but still didn't work. I configured the bridge on both LAN config page and opt1 config page.. still no luck.. Then... I added any any any rules to both LAN and wireless interfaces and still it isn't working for me... Any suggestings would be greatly appreaciated.! thank you Jim --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
