Ok, I updated and the issue solved, but now when adding a Load Balancer Pool in the "list" field I see something strange: on my howto the list format is "WAN|(WanMonitorIpAddress)" and "WAN2|(Wan2MonitorIpAddress)". On my firewall installation the results are different, the list field is in that format: "|(WanMonitorIpAddress)" and "|(Wan2MonitorIpAddress)". It seems like that the Interfaces in the resulting config is missing. Even when I look at the load balancer's list the "Server/Gateway" field is empty and the monitor field has no corresponding interface.
Is it a configuration problem? 10x r3N0oV4 -----Messaggio originale----- Da: Scott Ullrich [mailto:[EMAIL PROTECTED] Inviato: giovedì 19 aprile 2007 19.35 A: support@pfsense.com Oggetto: Re: [pfSense Support] Load Balancer Behaviour? On 4/19/07, Quirino Santilli <[EMAIL PROTECTED]> wrote: > I was finally configuring pfSense as a multi-wan / load-balancing / > fail-over firewall for my company when i found something strange. > > Looking at the howto at this address > http://doc.pfsense.org/index.php/Multi-Wan/Load-Balancing i > found that the load-balancer had a "behaviour" field that in my 1.0.1 > installation is not available. To make you believe I'm not fooling, you can > find attached the interface that comes out in my installation and the one > available on the howto. > > > > Can you tell me why? Upgrade to a recent snapshot. http://snapshots.pfsense.com/FreeBSD6/RELENG_1/ Scott --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]