Good afternoon folks,
So I have A Cisco 7960 (VOIP phone) network booting, pulling a
TFTP config over an IPsec tunnel. The phone can make and recieve calls
fine. At times when I pick up an inbound call the caller can't hear me
right away, this did not happen when using the Cisco ASA so I believe
it is QOS related.. I am noticing that my qVOIPUp que never gets
traffic. Is this because this que is tied to the WAN as the outbound
interface and the WAN never sees the private address because
encryption happens before QOS? If this is the case would it be
possible to use ENC0 or ENCX as the in/out interface instead of the
WAN interface? If my logic isn't totally flawed that would act like
Cisco's QOS pre-classification when using IPSec tunnels with time
sensitive data. By the way thanks to the entire team, I have been
using this product a long time and it is a scalable fantastic product.
--
Wade Blackwell
"Integrity is often more painful and always more profitable than
perception management"
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
