Can I assume that this is an embedded device you're trying to upgrade?
If so, this is a reported issue and has been discussed several times on
this mailing list. Use the shell upgrade method provided or re-flash
your CF card.
Mike Lever wrote:
While trying to upgrade to 1.2 using the webgui update I received an error
during the next bootup
Loading /boot/defaults/loader.conf
Unable to load a kernel !
-
Cant load 'kernel'
It freezes there.. I've tried to reinstall from scratch, the setup runs fine
but freezes at the same point in bootup.
What did I do wrong and what can I do to correct it ? using the
Regards,
Mike Lever
Tenacity Films (Pty) Ltd t/a
Velocity Films
(T) +2711-807-0100
(F) 086-681-7518
http://www.velocityfilms.com
CONFIDENTIALITY CAUTION: If you have received this communication in error,
please note that it is intended for the addressee only, is privileged and
confidential and dissemination or copying prohibited. Please notify us
immediately by e-mail and return the original message. Thank you.
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
---------------------------------------------------------------------
To unsubscribe, e-mail: [EMAIL PROTECTED]
For additional commands, e-mail: [EMAIL PROTECTED]
