Hi Gary, Thanks for that info. I am using a standard installation not an embedded device (I think, I'm working off a standard desktop, HDD, no CF)
I also tried a fresh re-install and it installs fine, then boots up. I noticed the problem. The platform is CDROM and obviously disk usage is at 100%. So it appears to be working off the CD and not the HDD During installation, how do I set it to format the HDD and install on the hard drive ? I have watched the installation and it is all automated and doesn't allow me to set the target installation. Regards, Mike Lever Tenacity Films (Pty) Ltd t/a Velocity Films (T) +2711-807-0100 (F) 086-681-7518 http://www.velocityfilms.com CONFIDENTIALITY CAUTION: If you have received this communication in error, please note that it is intended for the addressee only, is privileged and confidential and dissemination or copying prohibited. Please notify us immediately by e-mail and return the original message. Thank you. -----Original Message----- From: Gary Buckmaster [mailto:[EMAIL PROTECTED] Sent: 28 Feb 2008 07:55 PM To: [email protected] Subject: Re: [pfSense Support] Load kernel error Can I assume that this is an embedded device you're trying to upgrade? If so, this is a reported issue and has been discussed several times on this mailing list. Use the shell upgrade method provided or re-flash your CF card. Mike Lever wrote: > While trying to upgrade to 1.2 using the webgui update I received an error > during the next bootup > > Loading /boot/defaults/loader.conf > Unable to load a kernel ! > - > Cant load 'kernel' > > It freezes there.. I've tried to reinstall from scratch, the setup runs fine > but freezes at the same point in bootup. > > What did I do wrong and what can I do to correct it ? using the > Regards, > > > Mike Lever > > Tenacity Films (Pty) Ltd t/a > Velocity Films > > (T) +2711-807-0100 > (F) 086-681-7518 > > http://www.velocityfilms.com > > > CONFIDENTIALITY CAUTION: If you have received this communication in error, > please note that it is intended for the addressee only, is privileged and > confidential and dissemination or copying prohibited. Please notify us > immediately by e-mail and return the original message. Thank you. > > > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] --------------------------------------------------------------------- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
