Hi Jesse,
I just had the same exact scenario. I had a DSL connection with a /29
subnet (5 usable ips), then last week I added another /29 subnet. The
new block is in a completely different subnet than the original one.
This is how I configure it. The original subnet was setup with CARP
virtual IP's (1 for every ip), all I did for the new block is adding a
new virtual ip network, this time using Proxy Arp and entering the new
/29 subnet. I left the WAN address and everything else untouched and it
all just worked. Not sure if using CARP for the new subnet would work as
well, I haven't tried it.
I hope this will work for you. I'm using 1.2.3-RC1 btw.
Max
Jesse Vollmar wrote:
Hey guys,
after googling this for a while, I'm not finding any clear
instructions for doing this. I currently have a multi-wan scenario
with failover configured. I just purchased another static IP block
from one of the ISPs and they are now routing those to me (so they
say). I would like to use this new subnet in concurrence with my old
subnet, both on the same interface (OPT1). The subnets do not share
the same gateway. What is the proper way to configure this?
Thanks,
Jesse
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
