> -----Original Message-----
> From: Chris Buechler [mailto:[email protected]]
> Sent: Thursday, October 01, 2009 2:58 PM
> To: [email protected]
> Subject: Re: [pfSense Support] Load Balanced Passive FTP?
>
> On Thu, Oct 1, 2009 at 4:57 PM, Nathan Eisenberg
> <[email protected]> wrote:
> > Is there a way to load balance a range of ports with one rule?
>
> Same way you load balance one port. Create a rule that specifies the
> range.
>
Not sure I follow... If I go to set up a new pool with a port-range, I get :
'The following input errors were detected:
* The port must be an integer between 1 and 65535.'
Best Regards,
Nathan Eisenberg
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
