Fra: mehma sarja [mailto:[email protected]]
Sendt: 18. november 2009 07:36
Til: [email protected]
Emne: Re: [pfSense Support] Booting from CF, full install
Anders,
Hold off on that drive, please try to upgrade the firmware first. I seem to
recall getting that same error. Something in my old age has forced me to
start reading the documentation and my Alix board had .99 and not .99 <some
letter> firmware version. I tried forcing a new version of s/w on cf card
and got that error. After the firmware upgrade, the rest went smoothly.
Yudhvir
===
On Thu, Nov 12, 2009 at 12:14 AM, <[email protected]> wrote:
On Thu, Nov 12, 2009 at 11:13, Morgan Reed <[email protected]> wrote:
> Most CF-IDE adapters I've come across aren't wired to allow the BIOS
> to negotiate DMA with the CF card;
>
> Try setting the following in your /etc/loader.conf
> hw.ata.ata_dma="0"
> hw.ata.atapi_dma="0"
Hmmm, I blame lack of coffee... Re-reading your log it looks like the
bootloader doesn't like the geometry of the CF card, not sure what can
be done about this.
Thank you for answering. I think I'll go with a hard drive instead.
Kind regards Anders
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
