Today I had an issue where the pfsense firewall (1.2.3RC3) could not
access the remote syslog on another server because of a network fault
(dead switch).
The end result of this was the firewall stopped responding after
behaving intermittently. I imagine the firewall buffered the messages
until the memory was full.
If there an automated way of telling the firewall to not use remote
syslog if it is not available? I would prefer to lose the logs rather
than have an unstable firewall.
Regards,
Duncan
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
