Chuck,
I am running DD-WRT on the WRT160nl. What I am attempting to achieve
is to setup the WRT to provide wireless access to my devices, as well
as allow my servers to be connected to the LAN.
I could use the WRT to bridge to the clear device, but then I would
only be able to hardwire my servers, and not be able to use it as an
AP for the laptops. More importantly, I am looking to implement QoS,
hence me using pfsense as the go between.
ClearSPOT ---> Pfsense --> 160nl --> LAN Clients
The only issue that I am having right now is trying to tweak the
config.xml to bring up the prism2 card up as the WAN interface. I see
the section on the wireless section, but at a loss on what I should be
changing.
<blockbogons/>
<disableftpproxy/>
<dhcphostname></dhcphostname>
<media></media>
<mediaopt></mediaopt>
<bandwidth>100</bandwidth>
<bandwidthtype>Mb</bandwidthtype>
<!--
<wireless>
*see below (opt[n])*
</wireless>
-->
</wan>
<!--
<opt[n]>
<enable/>
<descr></descr>
<if></if>
<ipaddr></ipaddr>
<subnet></subnet>
<media></media>
<mediaopt></mediaopt>
<bridge>lan|wan|opt[n]</bridge>
<wireless>
<mode>hostap *or* bss *or* ibss</mode>
<ssid></ssid>
<channel></channel>
<wep>
<enable/>
<key>
<txkey/>
<value></value>
</key>
</wep>
</wireless>
</opt[n]>
-->
I think once I have that in place, I will be good to go... Any pointer
on the setup of the above would be greatly appreciated!
--
Kim Callis
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
