> On Tue, Jan 4, 2011 at 1:08 AM, <[email protected]> wrote: > >> > On Tue, Jan 4, 2011 at 12:59 AM, Chris Buechler <[email protected]> >> > wrote: >> > >> >> >> >> >> >> On Tue, Jan 4, 2011 at 12:56 AM, DuWayne Odom <[email protected]> >> >> wrote: >> >> >> >>> I am attempting to use Shrewsoft VPN Client to connect to a Cisco >> VPN >> >>> Concentrator at work. I had no issue connecting while using >> m0n0wall, >> >>> but >> >>> now that I have switched to pfSense I have been unable to get it to >> >>> work >> >>> correctly. >> >>> >> >>> The client appears to connect and displays the Client Login Banner. >> >>> After >> >>> approx 20-30 seconds the connection drops. >> >>> >> >>> I have attempted to use all kinds of suggestions from the forums and >> >>> other >> >>> sources with no luck. >> >>> >> >>> Below is what I used to get it to at least connect for the short >> time >> >>> it >> >>> does. >> >>> >> >>> >> >> Delete the rule for UDP 4500 in your outbound NAT. With that gone you >> >> should be fine. >> >> >> >> >> > >> > I just removed that line again and still the same issue. :-( >> > >> You have ESP and UDP port 500 allowed on LAN, right? >> >> > Yes I allow all as seen below... > > Do tcpdump on WAN and see what is going on (at least you'll see whether you have right NAT)
--------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
