According to page 15 of the reference manual "address learning" is:
Enable or disable MAC address learning for the selected ports. When
Enabled, destination and
source MAC addresses are automatically listed in the forwarding table.
When address learning
is Disabled, MAC addresses must be manually entered into the forwarding
table. This is
sometimes done for reasons of security or efficiency. See the section on
Forwarding/Filtering
for information on entering MAC addresses into the forwarding table. The
default setting is
Enabled.
One other thing. I need to note that I have dedicated a CARP interface
on each Pfsense box connected to each over via a cross-over cable.
On 2/9/2011 2:35 PM, [email protected] wrote:
[snip]
Address Learning enabled on the Switch (default setting):
[snip]
Can you briefly explain what 'address learning' is according to D-Link?
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
