Could you use virtual IPs assigned to the wan interface? I use them now for a different subnet and it works fine for me. I assign the virtual IP and use 1:1 nat.
Ryan Rodrigue P.O. Box 4336 Systems Technician Houma, LA 70361 A A R Electronics, Inc Phone (985) 876-4096 510 West Tunnel Blvd Phone (800) 649-7346 Houma, LA 70360 Fax (985) 853-1034 [email protected] www.aarelectronics.com -----Original Message----- From: JASON JAMES [mailto:[email protected]] Sent: Tuesday, March 01, 2011 11:02 AM To: [email protected] Subject: [pfSense Support] Multiple WAN subnets We currently use PFSense as a perimeter firewall it does all of our NAT as well. We recently ran out of public ip's and had another subnet issued to us. The problem is whether I add a new interface or set it up as a static route we can't get it to be reachable from outside. I know I am missing something small, I have been skimming through the pFsense book again and nothing is popping out. Anyone have any ideas? If I add it as an interface, I can ping whatever ip address I bind that interface too but adding virtual ips and then setting up NAT for additional ips in that block are not routeable. --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org __________ Information from ESET NOD32 Antivirus, version of virus signature database 5917 (20110301) __________ The message was checked by ESET NOD32 Antivirus. http://www.eset.com
