From: Jim Pingle [mailto:[email protected]] Sent: Tuesday, March 08, 2011 5:26 PM To: [email protected] Subject: Re: [pfSense Support] OpenVPN issues
On 3/8/2011 5:21 PM, k_o_l wrote: >> From: Jim Pingle [mailto:[email protected]] >> On 3/8/2011 3:02 PM, k_o_l wrote: >>> I had working OpenVPN with pfsense 1.2.3, however with 2.0-RC1 the >>> server is handing the wrong mask and no gateway to the clients, I have >>> tried the wizard and changing different subnets, no matter what the >>> server is handing out /30 instead of /32. Firewalls rules are in place >>> to allow clients through the firewall. Any ideas? >> >> OpenVPN in tun mode has always handed out a /30 to clients. >> >> Were you using tap mode before? (That wasn't really supported...) > > I was using tunnel mode, and was getting /24, now only getting /30 and > 0.0.0.0 for gateway You would not have gotten a /24 on the client from OpenVPN in tun mode in a stock config. Sure you didn't have any special settings? http://bit.ly/ijlWpJ Jim --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org -----Original Message----- Just under address pool I had 10.168.2.0/24, I'm fine with not getting /24 with the new setup, as long as I can communicate client-to-client and of course resolve the issue with the quad zero gateway --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected] Commercial support available - https://portal.pfsense.org
