There was some issue with the snap shot , I move my firewall back to snap shot of 7th June 2011 form 10th June and it worked im not on RC 3 yet , what you say about RC3 is it going Fine ?
Regards, On Mon, Jun 20, 2011 at 8:04 PM, Roberto Nunnari <[email protected]>wrote: > Hi. > > > > Mr Router wrote: > >> Just upgraded to RC 2 will check this now and update my findings >> > > Could you replicate the problem? > Today I upgrade to RC3 and now the problem seems solved. > > Best regards. > Robi > > > >> On 6/10/11, Roberto Nunnari <[email protected]> wrote: >> >>> Mr Router wrote: >>> >>>> It is required to use reset states some time is real time traffic is >>>> running form the IP on which you are applying the rules , but commonly >>>> it works without it.reboot is not required ! >>>> >>> It doesn't work like that for me.. I just delete or add the rule that >>> let me in to the wan interface ip from an ip on the wan, but it doesn't >>> work until the pfSense box is rebooted. >>> >>> 1) delete rule >>> 2) save >>> 3) apply changes >>> 4) access from the wan still works! >>> 5) reset states >>> 5) access from the wan still works! (once still worked for a couple of >>> minutes, then became unreacheable from wan) >>> 6) after 15 minutes that it is still reacheable from wan, reboot >>> 7) access from the wan is now denied >>> 8) add again the firewall rule >>> 9) save and apply changes >>> 10) access from the wan still doesn't work! >>> 11) reset states >>> 12) access from the wan still doesn't work! >>> 13) reboot >>> 14) access from the wan works again >>> >>> As you see, apart from once, it always need a reboot to apply a simple >>> rule delete or add! >>> >>> I even reset pfSense to the factory defaults, but nothing change. >>> >>> So.. it is this a bug in 2.0-RC2 or is it some misconfiguration on my >>> side? >>> >>> Best regards. >>> Robi >>> >>> >>> >>>> On Fri, Jun 10, 2011 at 12:45 PM, Roberto Nunnari >>>> <[email protected] >>>> <mailto:roberto.nunnari@supsi.**ch<[email protected]>>> >>>> wrote: >>>> >>>> David Burgess wrote: >>>> >>>> On Thu, Jun 9, 2011 at 10:59 AM, Roberto Nunnari >>>> <[email protected] >>>> <mailto:roberto.nunnari@supsi.**ch<[email protected]> >>>> >> >>>> wrote: >>>> >>>> Hi. >>>> >>>> I just discovered that modifications to the firewall rules >>>> will not be >>>> active until the box is rebooted.. >>>> >>>> Is it a known bug or a misconfiguration on my side? >>>> >>>> >>>> Did you try this? >>>> >>>> >>>> http://doc.pfsense.org/index.**php/Reset_States<http://doc.pfsense.org/index.php/Reset_States> >>>> >>>> db >>>> >>>> >>>> I'll try that, too. >>>> Thank you. >>>> Robi >>>> >>>> >>>> >>>> ------------------------------**----------- >>>> Regards, >>>> >>>> Mr.Router >>>> >>> > > ------------------------------**------------------------------**--------- > To unsubscribe, e-mail: > support-unsubscribe@pfsense.**com<[email protected]> > For additional commands, e-mail: [email protected] > > Commercial support available - https://portal.pfsense.org > > -- ----------------------------------------- Regards, Mr.Router
