Mr Router wrote:
There was some issue with the snap shot , I move my firewall back to
snap shot of 7th June 2011 form 10th June and it worked im not on RC 3
yet , what you say about RC3 is it going Fine ?
Yes. It is working fine for me, now that I'm on RC3.
Regards,
On Mon, Jun 20, 2011 at 8:04 PM, Roberto Nunnari
<[email protected] <mailto:[email protected]>> wrote:
Hi.
Mr Router wrote:
Just upgraded to RC 2 will check this now and update my findings
Could you replicate the problem?
Today I upgrade to RC3 and now the problem seems solved.
Best regards.
Robi
On 6/10/11, Roberto Nunnari <[email protected]
<mailto:[email protected]>> wrote:
Mr Router wrote:
It is required to use reset states some time is real
time traffic is
running form the IP on which you are applying the rules
, but commonly
it works without it.reboot is not required !
It doesn't work like that for me.. I just delete or add the
rule that
let me in to the wan interface ip from an ip on the wan, but
it doesn't
work until the pfSense box is rebooted.
1) delete rule
2) save
3) apply changes
4) access from the wan still works!
5) reset states
5) access from the wan still works! (once still worked for a
couple of
minutes, then became unreacheable from wan)
6) after 15 minutes that it is still reacheable from wan, reboot
7) access from the wan is now denied
8) add again the firewall rule
9) save and apply changes
10) access from the wan still doesn't work!
11) reset states
12) access from the wan still doesn't work!
13) reboot
14) access from the wan works again
As you see, apart from once, it always need a reboot to
apply a simple
rule delete or add!
I even reset pfSense to the factory defaults, but nothing
change.
So.. it is this a bug in 2.0-RC2 or is it some
misconfiguration on my side?
Best regards.
Robi
On Fri, Jun 10, 2011 at 12:45 PM, Roberto Nunnari
<[email protected]
<mailto:[email protected]>
<mailto:roberto.nunnari@supsi.__ch
<mailto:[email protected]>>> wrote:
David Burgess wrote:
On Thu, Jun 9, 2011 at 10:59 AM, Roberto Nunnari
<[email protected]
<mailto:[email protected]>
<mailto:roberto.nunnari@supsi.__ch
<mailto:[email protected]>>>
wrote:
Hi.
I just discovered that modifications to the
firewall rules
will not be
active until the box is rebooted..
Is it a known bug or a misconfiguration on my
side?
Did you try this?
http://doc.pfsense.org/index.__php/Reset_States
<http://doc.pfsense.org/index.php/Reset_States>
db
I'll try that, too.
Thank you.
Robi
------------------------------__-----------
Regards,
Mr.Router
--
-----------------------------------------
Regards,
Mr.Router
---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]
Commercial support available - https://portal.pfsense.org
