Hi Mark,
> On 19 Jun 99, you wrote...
>These types of cards do work pretty good. The 386 I had used a cheapie
> controller and when I added a 600MB hard drive I had nothing but
> trouble, especially with utilities like Norton Disk Doctor (anything
> above the DOS limit was seen as bad).
> I picked up SIIG's EIDE Upgrade Enhancer Board which fixed the problem
> and I was able to use the whole drive. I later replaced it with another
> SIIG controller with better I/O. The limit of both cards was 8.4GB.
Do you plug in the card and that's it? Or do you plug in the card, disable
the HHD controller and plug in the 40-wire cable to the new card? Is it a
8-bit, 16-bit ISA, or PCI card? Does it need a software driver to put the
HDD to work? I ask you so many questions because it's
the first time I hear of a card like this one.
Could you tell the email, physical, or website address of SIIG?
Is there a retail company that sells it through international credit card
orders?
Any other information you think to be relevant will be welcomed.
Thanks in advance,
Jorge Rieznik
To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with
unsubscribe SURVPC in the body of the message.
Also, trim this footer from any quoted replies.
