Hello,
I thought I would take a moment of your time, to share these
instructions with the list. It seems that from time to time we get a
person who has trouble unsubbing themselves from one of the many lists
we are on, so in sharing these instructions.... maybe we can avoid
problems!
Heres how to unsubscribe from a SurvPC-User-list:
First, ask your Internet Provider to mail you an
Unsubscribing Kit. Then follow these directions.
The kit will most likely be the standard no-fault type.
Depending on requirements, System A and/or System B
can be used. When operating System A, depress lever
and a plastic dalkron unsubscriber will be dispensed
through the slot immediately underneath. When you have
fastened the adhesive lip, attach connection marked by
the large "X" outlet hose. Twist the silver- coloured ring
one inch below the connection point until you feel it lock.
The kit is now ready for use. The Cin-Eliminator is
activated by the small switch on the lip. When securing,
twist the ring back to its initial condition, so that the two
orange lines meet. Disconnect. Place the dalkron
unsubscriber in the vacuum receptacle to the rear.
Activate by pressing the blue button.
The controls for System B are located on the opposite
side. The red release switch places the Cin-Eliminator
into position; it can be adjusted manually up or down by
pressing the blue manual release button.
The opening is self- adjusting. To secure after use,
press the green button, which simultaneously activates
the evaporator and returns the Cin-Eliminator to its
storage position.
You may log off if the green exit light is on over the
evaporator . If the red light is illuminated, one of the Cin-
Eliminator requirements has not been properly
implemented. Press the "List Guy" call button on the right
of the evaporator . He will secure all facilities from his
control panel.
To use the Auto-Unsub, first undress and place all your
clothes in the clothes rack. Put on the velcro slippers
located in the cabinet immediately below. Enter the
shower, taking the entire kit with you. On the control
panel to your upper right upon entering you will see a
"Shower seal" button. Press to activate. A green light will
then be illuminated immediately below. On the intensity
knob, select the desired setting. Now depress the Auto-
Unsub activation lever. Bathe normally.
The Auto-Unsub will automatically go off after three
minutes unless you activate the "Manual off" override
switch by flipping it up. When you are ready to leave,
press the blue "Shower seal" release button. The door
will open and you may leave. Please remove the velcro
slippers and place them in their container.
If you prefer the ultrasonic log-off mode, press the
indicated blue button. When the twin panels open, pull
forward by rings A & B. The knob to the left, just below
the blue light, has three settings, low, medium or
high. For normal use, the medium setting is suggested.
After these settings have been made, you can activate
the device by switching to the "ON" position the clearly
marked red switch. If during the unsubscribing operation,
you wish to change the settings, place the "manual off"
override switch in the "OFF" position. You may now
make the change and repeat the cycle. When the green
exit light goes on, you may log off and have lunch.
Please close the door behind you.
:-) I had to pass this on :-)
Chad Fernandez
Michigan, USA
To unsubscribe from SURVPC send a message to [EMAIL PROTECTED] with
unsubscribe SURVPC in the body of the message.
Also, trim this footer from any quoted replies.
More info can be found at;
http://www.softcon.com/archives/SURVPC.html
