Hi Just checking but have you checked that the SCSI bus is properly terminated and that the device addresses are not overlapping. I would then try the elimination system and take out all but the most needed disk(s)/devices and add them in one by one once you get SuSE installed.
Good luck Andrew Hooper www.andrew.hooper.dsl.pipex.com -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Sent: 09 June 2003 07:20 To: [EMAIL PROTECTED] Subject: [suse-sparc] Booting SParc 10 Hello All, New to list. I am booting disk 1. I do a text or Yast2 install. I get into the startup, and after the scsi disks are recognized, I get a never ending list of SCSI interrupt errors. Any ideas? By the way - 2 Narrow SCSI disks, 2 Gb each and an external cartridge type cdrom. SMP system with 2 Ross 150 Mhz modules.. TIA. Steve -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED] -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
