Success.. Pulled out one hard drive and temporarily hung a cdrom over the first hard drive. Connected cdrom drive to second hard drive cable. Boots, but now other media issues occur during second session...
Until next time.. Steve On Mon, 9 Jun 2003 10:08:58 +0100 "Andrew Hooper" <[EMAIL PROTECTED]> wrote: > Hi > > Just checking but have you checked that the SCSI bus is properly terminated > and that the device addresses are not overlapping. I would then try the > elimination system and take out all but the most needed disk(s)/devices and > add them in one by one once you get SuSE installed. > > Good luck > > Andrew Hooper > www.andrew.hooper.dsl.pipex.com > > -----Original Message----- > From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] > Sent: 09 June 2003 07:20 > To: [EMAIL PROTECTED] > Subject: [suse-sparc] Booting SParc 10 > > > Hello All, > > New to list. > > I am booting disk 1. I do a text or Yast2 install. I get into the > startup, > and after the scsi disks are recognized, I get a never ending list of SCSI > interrupt errors. Any ideas? > > By the way - 2 Narrow SCSI disks, 2 Gb each and an external cartridge > type > cdrom. SMP system with 2 Ross 150 Mhz modules.. > > > TIA. > > > Steve > > -- > To unsubscribe, e-mail: [EMAIL PROTECTED] > For additional commands, e-mail: [EMAIL PROTECTED] > > -- To unsubscribe, e-mail: [EMAIL PROTECTED] For additional commands, e-mail: [EMAIL PROTECTED]
