On 6:24:09 am 09/27/07 "Patrick Shirkey" <[EMAIL PROTECTED]> wrote: > On 6:38:05 pm 09/26/07 Scott Gifford <[EMAIL PROTECTED]> wrote: > > > > > > It seems sourceforge can't search html attachments on archive > > > mail so that thread doesn't show up in a standard search of the > > archive. > > That's odd, it shouldn't have been in any kind of attachment; my > > mail reader doesn't even support composing HTML email. > > > > It looks like sf.net archives some emails in strange ways. > > > > > I can get multiple devices to show up now after running > > > > > > > > > synce-serial-start /dev/ttyUSB0 > > > synce-serial-start /dev/ttyUSB1 > > > > > > After this I get two new devices on ppp0 and ppp1. However ppp1 > > > only stays up for about 3 seconds. I have tried swapping the > > > devices and starting them in opposite order and it doesn't make > > > any difference. > > > > > > Do you have any ideas on what would cause this issue? > > > > Look in the logs for clues. You would see this behavior running > > dccm instead of vdccm. If you're already running vdccm, turn up > > debugging and you should be able to see what's going on. > >
Hi, I definitely don't have dccm installed. I have checked the logs and the relevant message is below. What it says is that the ppp0 device is registered and stays connected but het ppp1 device is registered and then disconnected quickly. I have found some info on this page but it doesn't make sense as I can get the same device to register and stay connected as ppp0 http://synce.sourceforge.net/synce/qa.php *********************** PPP error: "LCP terminated by peer" Q: My PPP session was terminated with the message with "LCP terminated by peer" after a very short connection time. I see something like this in my logs: pppd[21318]: pppd 2.4.2 started by root, uid 0 pppd[21318]: Serial connection established. pppd[21318]: Using interface ppp0 pppd[21318]: Connect: ppp0 <--> /dev/ttyUSB0 kernel: PPP BSD Compression module registered kernel: PPP Deflate Compression module registered pppd[21318]: local IP address 192.168.131.102 pppd[21318]: remote IP address 192.168.131.201 pppd[21318]: LCP terminated by peer pppd[21318]: Connection terminated. pppd[21318]: Connect time 0.1 minutes. pppd[21318]: Sent 579 bytes, received 857 bytes. pppd[21318]: Connect time 0.1 minutes. pppd[21318]: Sent 579 bytes, received 857 bytes. pppd[21318]: Exit. A: The device password provided to dccm is either wrong or missing. See Connect for more information. *************** Here's the message: Sep 26 16:05:06 localhost kernel: usb 7-6.3.4: new full speed USB device using ehci_hcd and address 25 Sep 26 16:05:06 localhost kernel: usb 7-6.3.4: device descriptor read/64, error -32 Sep 26 16:05:07 localhost kernel: usb 7-6.3.4: configuration #1 chosen from 1 choice Sep 26 16:05:07 localhost kernel: ipaq 7-6.3.4:1.0: PocketPC PDA converter detected Sep 26 16:05:07 localhost kernel: usb 7-6.3.4: PocketPC PDA converter now attached to ttyUSB0 Sep 26 16:05:26 localhost pppd[6212]: pppd 2.4.4 started by patrick, uid 0 Sep 26 16:05:26 localhost pppd[6212]: Serial connection established. Sep 26 16:05:26 localhost pppd[6212]: Using interface ppp0 Sep 26 16:05:26 localhost pppd[6212]: Connect: ppp0 <--> /dev/ttyUSB0 Sep 26 16:05:26 localhost pppd[6212]: local IP address 192.168.131.1 Sep 26 16:05:26 localhost pppd[6212]: remote IP address 192.168.131.129 Sep 26 16:05:38 localhost kernel: usb 7-6.4: USB disconnect, address 24 Sep 26 16:05:38 localhost kernel: ipaq ttyUSB1: PocketPC PDA converter now disconnected from ttyUSB1 Sep 26 16:05:38 localhost kernel: ipaq 7-6.4:1.0: device disconnected Sep 26 16:05:39 localhost kernel: usb 7-6.4: new full speed USB device using ehci_hcd and address 26 Sep 26 16:05:39 localhost kernel: usb 7-6.4: configuration #1 chosen from 1 choice Sep 26 16:05:39 localhost kernel: ipaq 7-6.4:1.0: PocketPC PDA converter detected Sep 26 16:05:39 localhost kernel: usb 7-6.4: PocketPC PDA converter now attached to ttyUSB1 Sep 26 16:05:44 localhost pppd[6299]: pppd 2.4.4 started by patrick, uid 0 Sep 26 16:05:44 localhost pppd[6299]: Serial connection established. Sep 26 16:05:44 localhost pppd[6299]: Using interface ppp1 Sep 26 16:05:44 localhost pppd[6299]: Connect: ppp1 <--> /dev/ttyUSB1 Sep 26 16:05:44 localhost pppd[6299]: local IP address 192.168.131.2 Sep 26 16:05:44 localhost pppd[6299]: remote IP address 192.168.131.130 Sep 26 16:05:47 localhost pppd[6314]: LCP terminated by peer Sep 26 16:05:47 localhost pppd[6314]: Connect time 0.1 minutes. Sep 26 16:05:47 localhost pppd[6314]: Sent 368 bytes, received 1514 bytes. Sep 26 16:05:50 localhost pppd[6314]: Connection terminated. Sep 26 16:05:50 localhost pppd[6314]: Modem hangup Sep 26 16:05:50 localhost pppd[6314]: Exit. ************************** Cheers. -- Patrick Shirkey Boost Hardware Ltd. ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2005. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ SynCE-Devel mailing list SynCE-Devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/synce-devel
