Thanks Mark,I'm used to following the commands folks lay out (since I'm new to Linux) and sometimes forget to think about what they actually do.
Normally I dload a source tarball...extract...cd into that dir...do my configure/make/make install
Looking at your instructions I should have realized that would dload to the current dir (which is normally one I choose) went to my /home/bryan/ dir as I hadn't specifically selected another one ;-)
For the record though...the folder created is "librapi2_0.10.0" and not "librapi2_0.10.0-1jc2k1"...so the "blahblah" confused the newbie ;-)
Cheers -- Bryan Stevenson B.Comm. VP & Director of E-Commerce Development Electric Edge Systems Group Inc. phone: 250.480.0642 fax: 250.480.1264 cell: 250.920.8830 e-mail: [EMAIL PROTECTED] web: www.electricedgesystems.com Notice: This message, including any attachments, is confidential and may contain information that is privileged or exempt from disclosure. It is intended only for the person to whom it is addressed unless expressly authorized otherwise by the sender. If you are not an authorized recipient, please notify the sender immediately and permanently destroy all copies of this message and attachments.
------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/
_______________________________________________ SynCE-Devel mailing list SynCE-Devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/synce-devel
