On Fri, 2008-01-25 at 12:39 -0800, Bryan Stevenson wrote: > Thanks Mark, > > I'm used to following the commands folks lay out (since I'm new to > Linux) and sometimes forget to think about what they actually do. > > Normally I dload a source tarball...extract...cd into that dir...do my > configure/make/make install > > Looking at your instructions I should have realized that would dload > to the current dir (which is normally one I choose) went to > my /home/bryan/ dir as I hadn't specifically selected another one ;-) > > For the record though...the folder created is "librapi2_0.10.0" and > not "librapi2_0.10.0-1jc2k1"...so the "blahblah" confused the > newbie ;-) > > Cheers > > --
Cool, that's why I didn't put specific names in sometimes, you never know what the package contains for definite until you do it. Did it work ? Mark ------------------------------------------------------------------------- This SF.net email is sponsored by: Microsoft Defy all challenges. Microsoft(R) Visual Studio 2008. http://clk.atdmt.com/MRT/go/vse0120000070mrt/direct/01/ _______________________________________________ SynCE-Devel mailing list SynCE-Devel@lists.sourceforge.net https://lists.sourceforge.net/lists/listinfo/synce-devel
