Here is the first thing that came up when I googled this problem:
I don’t know if it is the software they are using but it shows that control
of bouncing is most likely at the AI2 end and not at our end nor the IP Host
end.
Also, it doesn’t address why the Talk list messages are being flagged as
spam - more research along these lines is necessary and I will continue
looking into this problem.
But the actual disabling of our accounts is controlled by AI2 if you read
below.
<Begin CopiedText>
  
EsoSoft Corporation 
 
 
 
Mailing List Hosting 
 
Service & Support 
 
 
 
 
 
 
www.esosoft.com/ 
 
Click for Live Support 
 close window
Bounce Processing
Unlike many other mail list managers, Mailman includes built-in bounce
handlers to help the list manager deal with addresses that have delivery
problems.  If you run large lists with dynamic membership then these
settings may save you a lot of time in helping to weed out addresses that go
bad. 
The settings on this page control the automatic bounce processing system in
Mailman. If you set Mailman to perform automatic bounce processing, here is
an overview of that process: 
 
When a bounce is received, Mailman will try to extract two pieces of
information from the bounce: 
 
 
1. The address of the list member which has generated the bounce.
 
 2. The severity of the problem which caused the bounce. 
 
 
The severity will be labeled either "hard" or "soft".
 
 If the bounce was caused by a fatal error (such as "user unknown"), the
severity will be labeled "hard".
 
 If the bounce was caused by a temporary error (such as "mailbox full"), the
severity will be labeled "soft".
 
 If Mailman is in doubt about the cause of the bounce, the severity will be
labeled "hard". 
 
If the address of the list member whose address has bounced cannot be found,
Mailman will either discard the bounce or send it to the list owner
(depending upon the settings you select on this page). 
 
Otherwise, each member is assigned a "bounce score". Each time a bounce is
caused by a particular member's e-mail address, the bounce score for that
member is increased. Hard bounces increase the member's bounce score by 1.
Soft bounces increase the member's bounce score by 0.5. Increases to a
particular member's bounce score happen only once per day. This means that
even if a member's e-mail address causes ten "hard" bounces in one day, that
member's bounce score will only increase by 1. 
 
If a member's bounce score exceeds the "bounce score threshold" (set by you,
below), the member's subscription is disabled - or the member is
unsubscribed - depending on your settings below. If the subscription is
disabled, the member will not receive any posting from the list until the
subscription is manually re-enabled (either by the list administrator or the
member). The member will, however, receive occasional reminders that the
subscription has been disabled. These reminder messages will include
information about how to re-enable the subscription. You control both the
number of reminders sent to the member as well as the frequency with which
the reminders are sent. 
 
You also set (below) the total number of reminder messages that will be sent
before Mailman permanently unsubscribes the address from the mailing list.
If you set this value to 0, Mailman will skip the entire "disable and send
reminders" period and unsubscribe the e-mail address immediately. 
 
 
 
 An important setting below is the "number of days to store a member's
bounce score". If a member's e-mail address generates no bounces during this
"number of days", the bounce score for this member is re-set to zero. By
adjusting this value along with the bounce score threshold, you can control
how quickly bouncing members are disabled and or unsubscribed. 
 
 
   
 
 
 
 
 
Value 
 
 
Description 
 
 
Should Mailman perform automatic bounce processing? 
 
Set this to Yes if you'd like Mailman to perform automatic bounce handling. 
 
The recommended setting for this option is: Yes 
 
 
The maximum member bounce score before the member's subscription is
disabled. This value can be a floating point number. 
 
This is the "bounce score threshold" as described above. 
 
The recommended setting for this option is: 2 
 
 
The number of days after which a member's bounce information is discarded,
if no new bounces have been received in the interim. This value must be an
integer. 
 
If a member's e-mail address generates no bounces during this period of time
(number of days), the member's bounce score is re-set to zero. 
 
The recommended setting for this option is: 30 
 
 
How many 
Your Membership Is Disabled
 warnings a disabled member should get before their address is removed from
the mailing list. Set to 0 to immediately remove an address from the list
once their bounce score exceeds the threshold. This value must be an
integer. 
 
If the member's subscription is disabled, how many reminder messages should
Mailman send to the member? 
Set this option to 0 if you would like Mailman to unsubscribe bouncing
addresses immediately. 
 
The recommended setting for this option is: 0 or 2 
 
 
The number of days between sending the 
Your Membership Is Disabled
 warnings. This value must be an integer. 
 
How often should the reminder messages be sent? 
The recommended setting for this option is: 7 
 
 
Should Mailman send you, the list owner, any bounce messages that failed to
be detected by the bounce processor? 
 
If Mailman cannot determine the e-mail address that is bouncing, should a
copy of the bounce be sent to the list owner? 
The recommended setting for this option is: Yes 
 
IMPORTANT:
 Mailman will do his absolute best to handle all of your list's bounces
automatically. However, there will be some bounces that require human
intervention. The list owner is required to provide that human assistance.
Mailing lists which generate bounces that are not acted upon violate
EsoSoft's Acceptable Use Policy. Inaction on the part of the list owner
could result in the deactivation of the mailing list. 
 
 
Should Mailman notify you, the list owner, when bounces cause a member's
subscription to be disabled? 
 
Select Yes if you would like to be notified when a member's subscription is
disabled. 
There is no recommended setting for this option. Either choice is fine. 
 
 
Should Mailman notify you, the list owner, when bounces cause a member to be
unsubscribed? 
 
Select Yes if you would like to be notified when a member is unsubscribed by
Mailman because of bounces. 
There is no recommended setting for this option. Either choice is fine. 
 
 
 
Back to the main Mailing List Support page 
. 
 
 
  
 
 
 
 
 
 
 
 
 
 
 
 
[ 
Contact Us 
] [ 
Legal 
] [... rest removed for brevity
<End CopiedText>

_______________________________________________
Any views or opinions presented in this email are solely those of the author 
and do not necessarily represent those of Ai Squared.

For membership options, visit 
http://lists.window-eyes.com/options.cgi/talk-window-eyes.com/archive%40mail-archive.com.
For subscription options, visit 
http://lists.window-eyes.com/listinfo.cgi/talk-window-eyes.com
List archives can be found at 
http://lists.window-eyes.com/private.cgi/talk-window-eyes.com

Reply via email to