Friday, December 19, 2003, 12:34:42 AM, you wrote:
> Alexander Leschinsky, [AL] wrote:
AM>>> For each view mode, you can use the Filter configuration to do
AM>>> this.
AL>> I tried filter and... got all messages listed, as it was without filter
AL>> I can send my VM-file for testing to everybody
> I just adjusted a view mode to filter:
> Message (attribute) .. is not .. read
> Upon rechecking folders using this view mode, only unread messages were
> displayed.
I have been unable to create a filter to show ALL messages, when the
generic setting under View : Display is Show Only Unread.
I think the whole mess wants re writing. It needs proper scripting like:
"These settings will apply across all folders not specifically set
differently", with a set up box. Then, when that is done, a pop up
appears saying "Go to any folders you wish displayed differently to the
generic setting above and using Properties, set those up as you wish
them to appear" Again, with a proper pop up box for each individual one.
I'd like to see a Gravity like filter display option permanently on
view, allowing rapid toggles of pre written display options, accessible
from every folder.
Thanks for the filter tips, what would I put to achieve the above
scenario though, please?
--
Best regards,
Chris Wilson
http://www.formula3.freeserve.co.uk
________________________________________________________
Current beta is 2.03.10 | "Using TBBETA" information:
http://www.silverstones.com/thebat/TBUDLInfo.html
