-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 On Tuesday, November 26, 2002, tracer wrote...
>> Look under Account -> Properties -> Options. Check "Allow >> send/fetch without entering the access password (if any)". That >> should do what you want. > thanks, shows that after all these years one is still learning... > reminds me, I just see that my post was semi bounced with following > message...: > Your mail to 'TBUDL' with the subject > password on messages > Is being held until the list moderator can review it for approval. > The reason it is being held: > Message may contain administrivia [snip] > question is really what triggered the toast... I obviously will > have a good look at the stromgrade website as it looks like an > intriguing message... mailman reads all mail going to lists and such, and sometimes grabs messages with certain keywords in (administrative), and save the list being flooded with accidental unsub commands, the list software often bounces it up to the list moderators/admin for approval. That is normally the case anyway ;) Just as a curious question... why do your replies have a *huge* gap between the "hello" stuff, and the reply message? This email I'm replying to was 1/2 way down the screen before it go to the original post, and on 1024x768 resolution, that is a fair chunk. - -- Jonathan Angliss ([EMAIL PROTECTED]) -----BEGIN PGP SIGNATURE----- Comment: Fingerprint: 676A 1701 665B E343 E393 B8D2 2B83 E814 F8FD 1F73 iQA/AwUBPeRKPyuD6BT4/R9zEQLs3ACfZQfZYKlzvJjo60IiLJm8mA8VJKwAoI5Q 5st75xyUtjcfSAtewS87WIIF =FkaN -----END PGP SIGNATURE----- ________________________________________________ Current version is 1.61 | "Using TBUDL" information: http://www.silverstones.com/thebat/TBUDLInfo.html
