I finally got it to boot successfully. Not sure what was up with the
hard drive errors. Maybe the file system wasn't clean? After I put
the drive in the laptop and let it boot Ok, it's been booting Ok in the
IP380. I'll see if I can get the network ports to work later today.
Thanks again for all the help!
Stan
[ using 749064 bytes of bsd ELF symbol table ]
Copyright (c) 1982, 1986, 1989, 1991, 1993
The Regents of the University of California. All rights reserved.
Copyright (c) 1995-2013 OpenBSD. All rights reserved.
http://www.OpenBSD.org
OpenBSD 5.3 (GENERIC) #50: Tue Mar 12 18:35:23 MDT 2013
dera...@i386.openbsd.org:/usr/src/sys/arch/i386/compile/GENERIC
cpu0: Intel Pentium III ("GenuineIntel" 686-class) 867 MHz
cpu0:
FPU,V86,DE,PSE,TSC,MSR,PAE,MCE,CX8,SEP,MTRR,PGE,MCA,CMOV,PSE36,PSN,MMX,FXSR,SSE
real mem = 1073278976 (1023MB)
avail mem = 1044758528 (996MB)
User Kernel Config
UKC> disable ohci
154 ohci* disabled
155 ohci* disabled
UKC> quit
Continuing...
mainbus0 at root
bios0 at mainbus0: AT/286+ BIOS, date 04/30/04, BIOS32 rev. 0 @ 0xe7650
pcibios0 at bios0: rev 2.1 @ 0xe76c0/0x600
pcibios0: PCI BIOS has 9 Interrupt Routing table entries
pcibios0: PCI Exclusive IRQs: 5 7 9 10 11
pcibios0: PCI Interrupt Router at 000:15:0 ("ServerWorks OSB4" rev 0x00)
pcibios0: PCI bus #4 is the last bus
cpu0 at mainbus0: (uniprocessor)
pci0 at mainbus0 bus 0: configuration mode 1 (bios)
pchb0 at pci0 dev 0 function 0 "ServerWorks CNB20LE Host" rev 0x06
pchb1 at pci0 dev 0 function 1 "ServerWorks CNB20LE Host" rev 0x06
pci1 at pchb1 bus 1
ppb0 at pci1 dev 0 function 0 "Intel 21154AE/BE PCI-PCI" rev 0x00
pci2 at ppb0 bus 2
fxp0 at pci2 dev 3 function 0 "Intel 82559ER" rev 0x10, i82551: irq 11,
address ff:ff:ff:ff:ff:ff
inphy0 at fxp0 phy 1: i82555 10/100 PHY, rev. 4
fxp1 at pci2 dev 4 function 0 "Intel 82559ER" rev 0x10, i82551: irq 11,
address ff:ff:ff:ff:ff:ff
inphy1 at fxp1 phy 1: i82555 10/100 PHY, rev. 4
fxp2 at pci2 dev 5 function 0 "Intel 82559ER" rev 0x10, i82551: irq 11,
address ff:ff:ff:ff:ff:ff
inphy2 at fxp2 phy 1: i82555 10/100 PHY, rev. 4
fxp3 at pci2 dev 6 function 0 "Intel 82559ER" rev 0x10, i82551: irq 11,
address ff:ff:ff:ff:ff:ff
inphy3 at fxp3 phy 1: i82555 10/100 PHY, rev. 4
ppb1 at pci1 dev 2 function 0 "Intel 21154AE/BE PCI-PCI" rev 0x00
pci3 at ppb1 bus 3
dc0 at pci3 dev 5 function 0 "DEC 21142/3" rev 0x41: irq 10, address
00:00:00:00:00:00
bmtphy0 at dc0 phy 1: BCM5221 100baseTX PHY, rev. 4
dc1 at pci3 dev 6 function 0 "DEC 21142/3" rev 0x41: irq 10, address
00:00:00:00:00:00
bmtphy1 at dc1 phy 1: BCM5221 100baseTX PHY, rev. 4
cbb0 at pci0 dev 9 function 0 "TI PCI1420 CardBus" rev 0x00: couldn't
map interrupt
cbb1 at pci0 dev 9 function 1 "TI PCI1420 CardBus" rev 0x00: couldn't
map interrupt
ubsec0 at pci0 dev 10 function 0 "Broadcom 5802" rev 0x01: 3DES MD5 SHA1
RNG PK, irq 11
piixpm0 at pci0 dev 15 function 0 "ServerWorks OSB4" rev 0x51: polling
iic0 at piixpm0
lmenv0 at iic0 addr 0x2d: lm87 rev 6
lmenv1 at iic0 addr 0x2e: lm87 rev 6
spdmem0 at iic0 addr 0x50: 512MB SDRAM registered ECC PC133CL2
spdmem1 at iic0 addr 0x51: 512MB SDRAM registered ECC PC133CL2
pciide0 at pci0 dev 15 function 1 "ServerWorks OSB4 IDE" rev 0x00: DMA
wd0 at pciide0 channel 0 drive 0: <FUJITSU MHT2040AS>
wd0: 16-sector PIO, LBA, 38154MB, 78140160 sectors
wd0(pciide0:0:0): using PIO mode 4, DMA mode 2, Ultra-DMA mode 2
"ServerWorks OSB4/CSB5 USB" rev 0x04 at pci0 dev 15 function 2 not
configured
isa0 at mainbus0
isadma0 at isa0
com0 at isa0 port 0x3f8/8 irq 4: ns16550a, 16 byte fifo
com0: console
com1 at isa0 port 0x2f8/8 irq 3: ns16550a, 16 byte fifo
pckbc0 at isa0 port 0x60/5
pckbd0 at pckbc0 (kbd slot)
pckbc0: using irq 1 for kbd slot
wskbd0 at pckbd0: console keyboard
pcppi0 at isa0 port 0x61
spkr0 at pcppi0
npx0 at isa0 port 0xf0/16: reported by CPUID; using exception 16
mtrr: Pentium Pro MTRR support
vscsi0 at root
scsibus0 at vscsi0: 256 targets
softraid0 at root
scsibus1 at softraid0: 256 targets
root on wd0a (f6446c169da91933.a) swap on wd0b dump on wd0b
Automatic boot in progress: starting file system checks.
/dev/rwd0a: file system is clean; not checking
/dev/rwd0k: file system is clean; not checking
/dev/rwd0d: file system is clean; not checking
/dev/rwd0f: file system is clean; not checking
/dev/rwd0g: file system is clean; not checking
/dev/rwd0h: file system is clean; not checking
/dev/rwd0j: file system is clean; not checking
/dev/rwd0i: file system is clean; not checking
/dev/rwd0e: file system is clean; not checking
setting tty flags
pf enabled
starting network
starting early daemons: syslogd pflogd.
starting RPC daemons:.
savecore: no core dump
checking quotas: done.
clearing /tmp
starting pre-securelevel daemons:.
setting kernel security level: kern.securelevel: 0 -> 1
creating runtime link editor directory cache.
preserving editor files.
starting network daemons: sendmail inetd sndiod.
starting local daemons: cron.
Sat Aug 24 09:30:40 CDT 2013
OpenBSD/i386 (gateway.home.pc) (tty00)
login: