Hi Members, This set has came back 2 times with the cassette stuck in the loaded position. After pushing the on/off, and eject buttons several times, it finally starts up, and starts working. I know I need to disassemble and clean the mode switch, Prisim, etc., and maybe replace the center LED,....but, before spending too much time on it, I would like to ask a question.
On the main power supply PC board, there is a 2.7 ohm 1/4 watt resistor that is tied to a pin on the Reg. IC (labeled R565). This resistor has a wire soldered across it, to give it a resistance of "0" ohms. Is this a factory modification ? It looks like a slopy soldering job, and I wounder if this could be related to my original problems. Should I remove the jumper wire ? Any help or suggestions are appreciated. LLW LeRoy Westlund Westlund TV & Electronics 97 North Main "At least I'll go down Centerfield, UT 84622-0087 swingin,......what a swingin Ph./Fax 435-528-3822 way to go." mailto:[EMAIL PROTECTED] _________________________________________ Please include original text when replying to this email. Once you get your unit repaired, please post the fix to the group. Order your tech repair CD today, Version 3.0 only $49.00-more monitor tips-user friendly program. [EMAIL PROTECTED] www.tech-repair.net ______ Techs mailing list [EMAIL PROTECTED] http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com Go to the link above and scroll to the bottom to enter your email address
