Have you checked the microswitches? They are the worst to go out and cause this problem. I would check all of them just to be sure.
LOL
Joe
Eugene Spooner wrote:
Is that bolted down to a metal ? If so , should read zero ohms ! Best: Eugene
LeRoy Westlund wrote:
Hi members, This Sharp micro-wave oven won't heat. Control panel counts down OK, but has no 115 A/C volts driving the high voltage transformer. The Primary interlock relay RY-2 is not activating. Also, the turn table does not turn. I found a fix in Jeff's Intrepid CD program that said to replace the Temperature thermistor part # FH-HZA041WREO. I found the thermistor, but it measures 235K ohm across it. Do you think that reading is too high ? Shouldn't a good thermistor read much less then that ? Does anyone have one they could measure, to confirm that this part is bad. I hate to order one, if it won't fix the problem.
TIA, LLW
LeRoy Westlund Westlund TV & Electronics 97 North Main "Where there's a will,... Centerfield, UT 84622-0087 There's always a way." Ph./Fax 435-528-3822 mailto:[EMAIL PROTECTED]
_______________________________________________ Tech Repair CD...order your just $49.00 plus shipping...One year of updates free. www.intrepid-video.com www.tech-repair.net Techs mailing list [EMAIL PROTECTED] http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com
-- Joe Dickerson Joe's TV & Appliance Rt 1 Box 3781 Jasper, Texas 75951 (409) 384-3325 use same no. for fax
_______________________________________________ Tech Repair CD...order your just $49.00 plus shipping...One year of updates free. www.intrepid-video.com www.tech-repair.net Techs mailing list [EMAIL PROTECTED] http://intrepid-video.com/mailman/listinfo/techs_intrepid-video.com
