Thanks! And Thanks once more for that very fast answer. Now it works. Clear - think Therion :-) - levels and so on
Apropo level? I have a survey on a level of about 500m given in one scrap. Another scrap (in the same File) contains a short passage with about 550m. The two scraps are connected at one station point. But Therion writes a map so that the higher "level" is below the lower. What is wrong? Markus -----Ursprüngliche Nachricht----- Von: therion-bounces at speleo.sk [mailto:therion-bounces at speleo.sk] Im Auftrag von Martin Sluka Gesendet: Mittwoch, 11. März 2009 18:38 An: List for Therion users Betreff: Re: [Therion] join command On 11.3.2009, at 18:03, Boldt, Markus wrote: > Hello, > in one case the "join" command doesn`t works on my computer. > Version Therion 5.2.7 > I have two scraps in one *.th2-file. There are only two lines (type > wall) in that second scrap. > So I have, like described in TB, given IDs to that two lines and to > two other lines in the first scrap. > Then I have written this command line in my *.th-file after > "endcenterline"-command. > join VH10_L1 at VH10:0 VH10_L3 at VH10:0 > It gives a "survey does not exist -- VH10" error. If I comment out the > line it works without a problem. > The map is written but the lines resp. the points of the lines are not > connected. And that was it, what I wanted to do. > > Where is the fault, which I make? > > survey does not exist -- VH10 > It means therion doesn't know the scrap VH10 in the level you use the join Have you input your .th2_file in survey where is the join? But in that case the craps will be in the same level as join, so you should use: "join VH10_L1:0 VH10_L3:0" instead. m.s. _______________________________________________ Therion mailing list Therion at speleo.sk http://mailman.speleo.sk/mailman/listinfo/therion
